READ ALL INSTRUCTIONS BEFORE USING THIS APPLIANCE

• Do not allow to be used as a toy. Close attention is necessary when used by or near children.

• Use only as described in this manual. Use only manufacturer’s recommended attachments.

• Do not use with damaged cord or plug. If the unit is not working as it should, has been dropped, damaged, left outdoors, or dropped into water, return it to a service center.

• Do not pull or carry by the cord, do not use cord as a handle, do not close a door on the cord, or pull cord around sharp edges or corners. Do not run appliance over cord. Keep cord away from heated surfaces.

• DO NOT UNPLUG BY PULLING CORD. To unplug, grasp plug, not cord.

• Do not handle plug or appliance with wet hands.

• Do not put any objects into openings. Do not use if openings are blocked; keep free of dust, lint, hair, and anything that may reduce air flow.

• KEEP HAIR, CLOTHING, LOOSE JEWELRY, FINGERS and all parts of the body away from openings and moving parts.

• Turn off all controls before unplugging.

• Use extra care when cleaning on stairs.

• Do not use to pick up flammable or combustible liquids, such as gasoline, or use in areas where they may be present.

• Connect to a properly grounded outlet only. See Grounding Instructions.

• Always disconnect cord from electrical outlet before servicing appliance.

• Never sweep off explosive liquids, combustible gases or undiluted acids and solvents. This includes petrol, paint thinner or heating oil which can generate explosive fumes or mixtures upon contact with the air. Acetone, undiluted acids and solvents must also be avoided as they can harm the materials on the machine.

• Do not vacuum up burning or smouldering objects!

This device must be grounded. If it should malfunction or break down, grounding provides a path of least resistance for electric current to reduce the risk of electric shock.

This device is equipped with a cord having an equipment grounding conductor and ground plug.

The plug must be plugged into an appropriate outlet that is properly installed and grounded in accordance with all local codes and ordinances.

CONNECT TO A PROPERLY GROUNDED OUTLET ONLY

---

1. Grounded outlet
2. Grounded outlet box
3. Grounded pin

The owner and/or user must have an understanding of the manufacturer’s operating instructions and warnings before using this device.

Warning information should be emphasized and understood.

If the operator is not fluent in English, the manufacturer’s instructions and warnings shall be read to and discussed with the operator in the operator’s native language by the purchaser/ owner, making sure that the operator comprehends its contents.

Owner and/or user must study and maintain for future reference the manufacturers’ instructions.

Before starting operation, the device must be in the operating position.

Do not start or operate the device, any of its functions or attachments, from any place other than from the designated operator's position.

Before leaving the operator’s position:

1. bring the device to a complete stop;

2. if the device must be on an incline, block the wheels.

Maintain a safe distance from the edge of ramps, platforms, and other similar working surfaces.

Do not add to, or modify the device.

Do not block access to fire aisles, stairways or fire equipment.

Yield the right of way to pedestrians and emergency vehicles such as ambulances and fire trucks.

Cross railroad tracks at an angle wherever possible. Do not park closer than 6 ft (1800 mm) to the nearest rail of a railroad track.

Keep a clear view of the path of travel and observe for other traffic, personnel, and safe clearances.

Under all travel conditions, operate the device at a speed that will permit it to be brought to a stop in a safe manner.

Do not indulge in stunt driving or horseplay.

Slow down for wet and slippery floors. Before driving over a dockboard or bridge plate, be sure that it is properly secured. Drive carefully and slowly across the dockboard or bridge plate, and never exceed its rated capacity.

When negotiating turns, reduce speed to a safe level consistent with the operating environment. Make the turns smoothly.

If the device is found to be in need of repair or in any way unsafe, or contributes to an unsafe condition, the matter shall be reported immediately to the user’s designated authority, and the device shall not be operated until it has been restored to safe operating condition.

If during operation the device becomes unsafe in any way, the matter shall be reported immediately to the user’s designated authority, and the device shall not be operated until it has been restored to safe operating condition.

Do not make repairs or adjustments unless specifically authorized to do so.

Operation of the device may be hazardous if maintenance is neglected or repairs, rebuilds, or adjustments are not performed in accordance with the manufacturer’s design criteria. Therefore, maintenance facilities (on or off premises), trained personnel, and detailed procedures shall be provided.

Maintenance and inspection of the device shall be performed in conformance with the following practices:

1. a scheduled planned maintenance, lubrication, and inspection system shall be followed; consult the manufacturer’s recommendations.

2. Only trained and authorized persons shall be permitted to operate a powered floor scrubber. Operators of powered floor scrubbers shall be qualified as to visual, auditory, physical, and mental ability to operate the equipment safely.

Avoid fire hazards and have fire protection equipment present in the work area. Do not use open pans of fuel or flammable cleaning fluids for cleaning parts.

Any device not in safe operating condition shall be removed from service.

Repairs shall not be made in Class I, Class II, and Class III locations.

Fire Prevention.The device shall be kept in a clean condition and reasonably free of lint, excess oil, and grease.

Noncombustible agents are preferred for cleaning the device. Flammable liquids [those having flash points at or above 100°F (37,8°C)] are not allowed. Precautions regarding toxicity, ventilation, and fire hazard shall be appropriate for the agent or solvent used.

Nameplate Visibility. The device type designations as shown on the nameplate and the type markers shall not be covered over with paint so that their identification information is obscured.

Read these original instructions and the safety instructions chapter before using the device for the first time. Proceed accordingly.

Keep these for future reference or for future owners.

When handing over the vehicle, please report any defects and shipping damage to your dealer or sales outlet immediately.

The packing materials can be recycled. Please dispose of packaging in accordance with the environmental regulations.

Electrical and electronic appliances / devices contain valuable, recyclable materials and often components such as batteries, rechargeable batteries or oil, which - if handled or disposed of incorrectly - can pose a potential threat to human health and the environment. However, these components are required for the correct operation of the appliance / device. Appliances / devices marked by this symbol are not allowed to be disposed of together with the household trash.

Current information on content materials can be found at: www.kaercher.de/REACH

The warranty conditions issued by our relevant sales company apply in all countries. We shall remedy possible malfunctions on your appliance within the warranty period free of cost, provided that a material or manufacturing flaw is the cause. In a warranty case, please contact your dealer (with the purchase receipt) or the next authorized customer service site.

(See overleaf for the address)

Only use original accessories and original spare parts. They ensure that the appliance will run fault-free and safely.

Information on accessories and spare parts can be found at www.kaercher.com.

This battery-powered device is a sweeper for cleaning carpets and various indoor textile floors. It has an anti-static roller brush and a built-in dust filter.

This device is intended for dry use only.

The sweeper is intended for commercial use.

Only use the sweeper in accordance with the information in these operating instructions. All uses other than this shall be regarded as not being in accordance with its intended use. The manufacturer is not responsible for any resultant damage; The risk for this is borne by the user alone.

No modifications may be made to the sweeper.

Only the surfaces approved by the company or its representatives may be driven on and cleaned.

This device is only intended for dry use and must not be used or placed outdoors in damp conditions.

The device is not intended to be used on inclines.

Never sweep or vacuum up explosive liquids, gases, undiluted acids and solvents (e.g. petrol, paint thinner, heating oil), they form explosive vapors or mixtures in combination with the suction air.

Never sweep or vacuum acetone, undiluted acids and solvents as they attack and damage the materials used on the device.

Never sweep or vacuum reactive metal dusts (e.g. aluminum, magnesium, zinc), they form explosive gases in combination with strong alkaline or acidic detergents.

Do not sweep or vacuum any burning or smoldering objects, as there is a risk of fire.

Do not sweep up any substances that pose a health risk.

Staying in hazard zones is prohibited. Operation in potentially explosive areas is prohibited.

Pushing/pulling or transporting objects is not permitted with this device.

Large textile areas e.g. in:

• Offices

• Hotels

• Shops

• Casinos

• Airports

• Tennis halls

• Exhibition halls

The device is available in 2 different variants:

• CVS 65/1 Bp Pack (1.517-300.0)

  Battery and charger included in scope of delivery

• CVS 65/1 Bp (1.517-301.0)

  Without battery and charger

Safety devices protect the user and may not taken out of operation or functionally circumvented.

Adhere to the safety instructions in the chapters!

The cover switch prevents the device from starting when the device cover is open.

The On/Off switch prevents the device from starting up unintentionally. Switch off the On/Off switch when switching off the device or in the event of danger.

If the roller brush is overloaded, the electronics switch off the device and the LED flashes.

In this case, switch off the device using the On/Off switch, and before switching it on again, turn the roller brush all the way up using the contact pressure adjustment.

The side brush is supplied with the device and must be attached to the device before initial startup.

See chapter “Changing the side brush”.

Charge the battery before initial startup.

A description of this can be found in the separate operating instructions for the battery and charger.

---

1. Insert the charged battery into the battery holder, slide it in as far as it will go and click into place.

A dust bag can be inserted into the waste container for easy and safe disposal of the waste.

• Daily maintenance

1. Check roller brush and side brush for wrapped straps.

2. Check the function of all control elements.

• Weekly maintenance

1. Check moving parts for ease of movement.

2. Check sealing strips in the sweeping area for adjustment and wear.

3. Check the roller brush and side brush for wear.

4. Check the filter box, clean the pre-filter if necessary.

5. Check dust filter, clean if necessary (depending on frequency of use, approx. every 10 hours).

• Monthly maintenance

1. Remove the roller brush and remove dirt from the drive pin (see chapter "Checking / changing the roller brush")

• Maintenance after wear and tear

1. Adjust or change sealing strips.

2. Change the roller brush.

3. Change the side brush.

1. Have maintenance work carried out in accordance with the inspection checklist.

Check and change the roller brush with the device tilted.

---

1. Bearing shell
2. Roller brush
3. Drive pin
4. Distance between sealing strip and retaining plate

   • Target: 31-33 mm

• Roller brush / side brush do not run or run incorrectly 

• Dust when sweeping / insufficient suction performance 

• Sweeping performance not satisfactory 

Remedy:

Remedy:

Remedy:

Below (extracts) is an overview of wear parts or optionally available accessories.