Read these original operating instructions and the enclosed safety instructions before using the device for the first time. Proceed accordingly.

Keep both books for future reference or for future owners.

Use the device only in accordance with the information in these operating instructions.

• This device is suitable for commercial use, e.g. in hotels, schools, hospitals, factories, shops, offices, and rental companies.

• The device is suitable for cleaning hard surfaces and carpets.

• The device is not suitable for polishing vehicles.

• Only equip the device with original accessories and spare parts.

• Never use the device in potentially explosive atmospheres.

Before using the device for the first time, read and observe these operating instructions and the accompanying brochure: Safety information for single disc machines, No. 5.956-251.0.

The packing materials can be recycled. Please dispose of packaging in accordance with the environmental regulations.

Electrical and electronic appliances contain valuable, recyclable materials and often components such as batteries, rechargeable batteries or oil, which - if handled or disposed of incorrectly - can pose a potential threat to human health and the environment. However, these components are required for the correct operation of the appliance. Appliances marked by this symbol are not allowed to be disposed of together with the household rubbish.

Current information on content materials can be found at: www.kaercher.com/REACH

Only use original accessories and original spare parts. They ensure that the appliance will run fault-free and safely.

Information on accessories and spare parts can be found at www.kaercher.com.

Check the contents for completeness when unpacking. If any accessories are missing or in the event of any shipping damage, please notify your dealer.

1. ATTENTION

   Risk of damage

   The fastening screw protruding over the brush body can cause scratches on the cleaning object if the brush is too heavily worn.

   Replace the cleaning brush in good time before the bristles are too short.

   Select the brush suitable for the cleaning task or the pad drive plate.

2. Make sure that the mains plug is unplugged.

3. Unscrew the screw for brush attachment.

   Use the Allen key provided for this.

   ---

   

   1. Driver
   2. Disc brush/pad
   3. Washer
   4. Screw

4. Place the brush or pad drive board on the driver.

5. Screw in and tighten the screw and washer.

6. Centre and press the pad onto the pad drive plate.

1. Loosen the adjustable handle by turning it anticlockwise.

   ---

   

   1. Handle

2. Swivel the handle into the desired position.

3. Tighten the handle by turning it clockwise.

The voltage specified on the type plate must match the voltage of the power source.

Use only extension cables with splash guards.

The mains plug/extension cable connection must not be immersed in water.

1. Unwind the extension cable completely from the device.

2. Set the power switch to "0".

3. Plug the mains plug into the socket.

Recommended speed:

1. Turn the brush speed rotary knob to the desired value.

1. Apply the detergent solution to the surface to be cleaned.

2. Hold the device by the handle.

3. Set the trigger to "I".

4. Hold the device with both hands and move the brush/pad over the surface to be cleaned.

   Note: Do not press the device onto the surface to be cleaned. The weight of the device is sufficient as contact pressure.

5. Repeat the cleaning process if heavily soiled.

6. Soak up the waste water with a wet vacuum cleaner or wipe it up with a cloth.

1. Set the power switch to "0".

2. Pull the mains plug out of the socket.

3. Clean the device with a moist cloth.

4. Wind the mains cable around the device casing.

   ---

   

5. Secure the end of the cable with the cable clip.

6. Park the device in the parking position.

   This prevents the brush from becoming deformed.

   ---

   

1. When transporting in vehicles, secure the device against slipping and tipping over according to the applicable guidelines.

1. Wash dirty pads at a maximum of 60 °C.

2. Clean the casing of the device with a damp cloth and then rub dry.

3. Check the mains cable for damage.

In the event of malfunctions that cannot be remedied using the following information, please contact customer service.

• Unsatisfactory cleaning results 

• The device vibrates strongly 

• The pad does not rotate 

Remedy:

• Replace the soiled pad and wash at a maximum of 60 °C.

• Replace a worn brush/pad.

• Check the suitability of the detergent used for the application.

• Check the suitability of the brush/pad used for the application.

Remedy:

• Check for central positioning of the pad on the pad drive board.

• Check the attachment of the brush/pad.

Remedy:

• Check if foreign objects are blocking the pad drive board. Remove any foreign objects if necessary.

• Plug the mains plug into the socket.

The warranty conditions issued by our relevant sales company apply in all countries. We shall remedy possible malfunctions on your appliance within the warranty period free of cost, provided that a material or manufacturing defect is the cause. In a warranty case, please contact your dealer (with the purchase receipt) or the next authorised customer service site.

(See overleaf for the address)

We hereby declare that the machine described below complies with the relevant basic safety and health requirements in the EU Directives, both in its basic design and construction as well as in the version placed in circulation by us. This declaration is invalidated by any changes made to the machine that are not approved by us.

Product: Floor cleaner

Type: 1.737-xxx

2006/42/EC (+2009/127/EC)

2014/30/EU

2011/65/EU

EN 60335-1

EN 60335-2-72

EN 62233: 2008

EN 55014-1: 2017 + A11: 2020

EN 55014-2: 1997+A1: 2001+A2: 2008

EN 61000-3-2: 2014

EN 61000-3-3: 2013

EN IEC 63000: 2018

-

The signatories act on behalf of and with the authority of the company management.

---

Documentation supervisor:

S. Reiser

Alfred Kärcher SE & Co. KG

Alfred-Kärcher-Str. 28 - 40

71364 Winnenden (Germany)

Ph.: +49 7195 14-0

Fax: +49 7195 14-2212

Winnenden, 2022/09/01

We hereby declare that the product described below complies with the relevant provisions of the following UK Regulations, both in its basic design and construction as well as in the version put into circulation by us. This declaration shall cease to be valid if the product is modified without our prior approval.

Product: Floor cleaner

Type: 1.737-xxx

S.I. 2008/1597 (as amended)

S.I. 2016/1091 (as amended)

S.I. 2012/3032 (as amended)

EN 60335-1

EN 60335-2-72

EN 62233: 2008

EN 55014-1: 2017 + A11: 2020

EN 55014-2: 1997+A1: 2001+A2: 2008

EN 61000-3-2: 2014

EN 61000-3-3: 2013

EN IEC 63000: 2018

-

The signatories act on behalf of and with the authority of the company management.

---

Documentation supervisor:

S. Reiser

Alfred Kärcher SE & Co. KG

Alfred-Kärcher-Str. 28 - 40

71364 Winnenden (Germany)

Ph.: +49 7195 14-0

Fax: +49 7195 14-2212

Winnenden, 2022/09/01