Read these original instructions and the enclosed safety instructions before using the device for the first time. Act in accordance with them.

Keep both books for future reference or for future owners.

• If the operating instructions and safety instructions are not observed, the device can be damaged and dangers could arise for users and other persons.

• Notify the dealer immediately in the case of shipping damage.

• Check the package contents when unpacking for missing accessories or for damage.

The packing materials can be recycled. Please dispose of packaging in accordance with the environmental regulations.

Electrical and electronic devices contain valuable, recyclable materials and often components such as batteries, rechargeable batteries or oil, which - if handled or disposed of incorrectly - can pose a potential danger to human health and the environment. However, these components are required for the correct operation of the device. Devices marked by this symbol are not allowed to be disposed of together with the household rubbish.

Current information on content materials can be found at: www.kaercher.de/REACH

• This wet/dry vacuum cleaner is designed to remove dry dirt and liquids.

• This device is suitable for commercial use, e.g. in hotels, schools, hospitals, factories, shops, offices, and rental companies.

1. Unpack the device and install the accessories.

   ---

   

• An additional paper filter bag can be used when vacuuming fine dust.

1. Unlock and remove the suction head.

2. Connect the paper filter bag.

   ---

   

   ---

   

3. Fit and lock the suction head.

1. Remove the brush strip.

   ---

   

2. Install the squeegees.

• The paper filter bag must always be removed when vacuuming wet substances.

• On completion of wet vacuum cleaning: Clean the float and container with a damp cloth and dry.

The suction hose is equipped with the clip 2.0 connection. All accessory parts with nominal width DN 35 and a clip 2.0 connection can be connected.

---

1. Connect the mains plug.

2. Switch on the device at the main switch.

1. Perform cleaning.

• The suction duct is equipped with a float.

• When the maximum permissible waste water level in the container is reached, the suction volume is interrupted.

1. Switch off the device at the main switch.

2. Drain the waste water via the drain hose.

   ---

   

1. Switch off the device at the main switch.

2. Pull out the mains plug.

1. Empty the dirt receptacle.

2. Vacuum off the inside and outside of the device and clean with a moist cloth.

1. Store the suction pipe, suction hose and mains cable as shown in the illustration.

   ---

   

2. Store the device in a dry room and secure it against unauthorised use.

1. Transport the unit as shown in the illustration.

   ---

   

2. When transporting the device in vehicles, secure it to prevent it from slipping or overturning in accordance with the respective valid guidelines.

The device may only be operated indoors.

1. Unlock and remove the suction head.

2. Turn the suction head by 180 ° and set it down.

3. Unscrew the securing nut.

4. Remove the cartridge filter.

5. Install new cartridge filter.

6. Insert and tighten the securing nut.

7. Fit and lock the suction head.

• Suction turbine does not start up 

• Suction turbine runs, but the device does not suck 

• Suction power decreases 

• Escaping dust when vacuuming 

Remedy:

1. Check the socket and the power supply fuse.

2. Check the mains cable and the mains plug of the device.

3. Switch on the device.

Cause:

Float closes suction duct

Remedy:

1. Empty the dirt receptacle.

Remedy:

1. Remove any blockages from the suction nozzle, suction pipe, suction hose or cartridge filter.

2. Change the filled paper filter bag.

3. Change the cartridge filter.

4. Check the drain hose for leaks.

Remedy:

1. Check that the cartridge filter is correctly fitted.

2. Change the cartridge filter.

If the malfunction cannot be corrected, the device must be checked by the Customer Service department.

• Suction turbine does not start up 

• Suction turbine runs, but the device does not suck 

• Suction power decreases 

• Escaping dust when vacuuming 

Remedy:

1. Check the socket and the power supply fuse.

2. Check the mains cable and the mains plug of the device.

3. Switch on the device.

Cause:

Float closes suction duct

Remedy:

1. Empty the dirt receptacle.

Remedy:

1. Remove any blockages from the suction nozzle, suction pipe, suction hose or cartridge filter.

2. Change the filled paper filter bag.

3. Change the cartridge filter.

4. Check the drain hose for leaks.

Remedy:

1. Check that the cartridge filter is correctly fitted.

2. Change the cartridge filter.

The warranty conditions issued by our sales company responsible apply in all countries. We shall remedy possible malfunctions on your device within the warranty period free of cost, provided that a material or manufacturing defect is the cause. In a warranty case, please contact your dealer (with the purchase receipt) or the next authorised customer service site.

You can find more detailed information at: www.kaercher.com/dealersearch

Only use original accessories and original spare parts. They ensure that the appliance will run fault-free and safely.

Information on accessories and spare parts can be found at www.kaercher.com.

We hereby declare that the machine described below complies with the relevant basic safety and health requirements in the EU Directives, both in its basic design and construction as well as in the version placed in circulation by us. This declaration is invalidated by any changes made to the machine that are not approved by us.

Product: Wet/dry vacuum cleaner

Type: 1.428-xxx

2006/42/EC (+2009/127/EC)

2011/65/EU

2014/30/EU

EN IEC 63000: 2018

EN 55014-1: 2017 + A11: 2020

EN 55014-2: 2015

EN 60335-1

EN 60335-2-69

EN 61000-3-2: 2014

EN 61000-3-3: 2013

EN 62233: 2008

-

The undersigned act on behalf and under the power of attorney of the company management.

---

Documentation supervisor:

S. Reiser

Alfred Kärcher SE & Co. KG

Alfred-Kärcher-Str. 28 - 40

71364 Winnenden (Germany)

Ph.: +49 7195 14-0

Fax: +49 7195 14-2212

Winnenden, 2020/10/01

We hereby declare that the product described below complies with the relevant provisions of the following UK Regulations, both in its basic design and construction as well as in the version put into circulation by us. This declaration shall cease to be valid if the product is modified without our prior approval.

Product: Wet/dry vacuum cleaner

Type: 1.428-xxx

S.I. 2008/1597 (as amended)

S.I. 2012/3032 (as amended)

S.I. 2016/1091 (as amended)

EN IEC 63000: 2018

EN 55014-1: 2017 + A11: 2020

EN 55014-2: 2015

EN 60335-1

EN 60335-2-69

EN 61000-3-2: 2014

EN 61000-3-3: 2013

EN 62233: 2008

-

The undersigned act on behalf and under the power of attorney of the company management.

---

Documentation supervisor:

S. Reiser

Alfred Kärcher SE & Co. KG

Alfred-Kärcher-Str. 28 - 40

71364 Winnenden (Germany)

Ph.: +49 7195 14-0

Fax: +49 7195 14-2212

Winnenden, 2020/10/01