Read these original instructions and the enclosed original instructions for the battery pack/charger before using the device for the first time. Act in accordance with them. Keep the booklets for future reference or for future owners.

• In addition to the notes in the operating instructions, you also need to take into consideration the general safety regulations and accident prevention guidelines applicable by law.

• Warnings and information notices attached to the device provide important information for hazard-free operation.

The lock blocks the power switch and prevents the device from switching on unintentionally.

The packing materials can be recycled. Please dispose of packaging in accordance with the environmental regulations.

Electrical and electronic devices contain valuable, recyclable materials and often components such as batteries, rechargeable batteries or oil, which - if handled or disposed of incorrectly - can pose a potential danger to human health and the environment. However, these components are required for the correct operation of the device. Devices marked by this symbol are not allowed to be disposed of together with the household rubbish.

Cleaning work producing in oily waste water, e.g. washing engines, washing undercarriages etc., may only be performed at washing stations with an oil separator.

Extraction of water from public waterways is not permitted in some countries.

Current information on content materials can be found at: www.kaercher.de/REACH

Use the battery pressure cleaner in private households only.

The pressure cleaner is intended for cleaning machines, vehicles, buildings, tools, façades, terraces, garden machines etc. using a water jet.

Only use the device with battery packs and chargers from the KÄRCHER 18 V Battery Power (+) system.

Suitable battery packs and chargers are marked with the KÄRCHER 18 V Battery Power (+) System symbol. Suitable battery packs bear the designation "Battery Power 18/... and Battery Power+ 18/...". Suitable chargers bear the designation "BC 18 V ...".

Only use original accessories and original spare parts. They ensure that the appliance will run fault-free and safely.

Information on accessories and spare parts can be found at www.kaercher.com.

Use only special accessories with the label “Handheld” and a blue plug.

The scope of delivery for the appliance is shown on the packaging. Check the contents for completeness when unpacking. If any accessories are missing or in the event of any shipping damage, please notify your dealer.

1. Charge the battery pack (see operating instructions for the battery pack).

1. CAUTION

   Risk of injury and damage if the battery pack is not engaged!

   A battery pack that is not properly engaged can fall out and cause injury or damage.

   Make sure that the battery pack engages correctly in the battery mount.

   Push the battery pack into the battery mount until it audibly clicks into place, see .

   ---

   

For the connection values, see the type plate or chapter Technical data.

Observe the water distribution company regulations.

1. Connect a garden hose with a plug coupling (not included in the scope of delivery) to the device:

   1. If the KÄRCHER suction hose was previously fitted: Screw the coupling onto the water connection.

   2. Push the plug coupling of the garden hose onto the coupling.

   ---

   

2. Connect the garden hose to the water line.

3. Open the water tap completely.

This pressure cleaner with the KÄRCHER suction hose is suitable for sucking in surface water, e.g.from folding buckets, rain barrels or ponds.

For maximum suction height, see chapter Technical data.

1. Unscrew the coupling on the water connection of the device.

2. Fill the suction hose with water.

3. Screw the suction hose onto the water connection of the device and hang it in a water source (e.g. rain barrel).

4. Vent the suction hose.

   Note

   If necessary, remove the spray lance before venting the suction hose.

   1. Start the device see chapter Starting the device.

   2. Operate the device until no more air bubbles can be seen in the suction hose.

   3. Release the power switch.

   4. Secure the power switch with the lock.

1. Mount the spray lance and nozzle:

   1. Press the spray lance into the device and

   2. and fasten it by turning it 90°.

   3. Push the nozzle onto the spray lance until it audibly clicks into place.

   ---

   

1. WARNING

   Risk of injury and damage!

   Danger of injury and damage when setting the spray type during operation.

   Switch off the device before setting the spray type.

   Turn the head of the multi jet nozzle to set the desired spray type (point jet, flat jet, rinsing jet, mist jet, pouring jet).

   ---

   

1. Start the device:

   1. Release the power switch lock.

   2. Press the power switch.

      The device switches on.

   ---

   

1. Spray the detergent sparingly on the dry surface and let it work for a while (do not let it dry).

2. Rinse off the loosened dirt with the pressure jet.

1. Release the power switch.

2. Secure the power switch with the lock.

1. Remove the battery pack:

   1. Press the battery pack unlocking button.

   2. Pull the battery pack out of the battery pack mount.

   ---

   

1. Release the power switch.

2. Close the water tap.

3. Press the power switch.

   The existing pressure in the device is relieved.

4. Disconnect the device from the water supply.

5. Secure the power switch with the lock.

6. Remove the battery pack (see chapter Removing the battery pack).

1. Finish operation, see chapter Ending operation.

2. Secure the device and accessories, according to the applicable regulations, against slipping and tipping over when transporting in vehicles.

1. Finish operation, see chapter Ending operation.

2. Store the device and accessories in an indoor space protected from frost and direct sunlight

The device is maintenance-free.

1. Clean the device with a moist cloth.

Clean the fine filter regularly.

1. Depressurize the device, see chapter Ending operation.

2. ATTENTION

   Risk of damage due to improper cleaning!

   The fine filter is damaged by improper cleaning.

   Clean the fine filter only under running water against its flow direction.

   Do not use sharp or hard objects such as needles or wire brushes.

   ATTENTION

   Risk of damage!

   The device may be damaged when operated without a fine filter.

   Do not operate the device without a fine filter or with a damaged fine filter.

   Check the fine filter for damage before installation and replace a damaged fine filter immediately.

   Clean the fine filter:

   1. Unscrew the coupling on the water spigot.

   2. Remove the fine filter.

   3. Clean the fine filter under running water against its normal flow direction.

      ---

      

3. Install the fine filter in the reverse order.

You can remedy minor faults using the following overview.

If in any doubt, please contact your authorised Customer Service.

• Device not running 

• Device switches off automatically 

• Device not building up pressure 

• Device leaking 

Cause:

The battery pack is not sitting properly in the device

Remedy:

1. Push the battery pack into the mounting in the device until it audibly latches into place.

Cause:

The charging state of the battery pack is too low

Remedy:

1. Charge the battery pack.

Cause:

The battery pack is overheated

Remedy:

1. Remove the battery pack from the device and allow it to cool down.

2. Do not the place the device and battery pack in direct sunlight.

Cause:

The battery pack or the charger are defective

Remedy:

1. Replace the battery pack or charger.

Cause:

Overheating of the device or battery pack

Remedy:

1. Let the device or the battery pack cool down.

Cause:

The nozzle is dirty

Remedy:

1. Use a needle to remove dirt from the nozzle hole.

2. Rinse the nozzle from the front with water.

Cause:

The water supply is too low

Remedy:

1. Open the water tap fully.

2. Check the water inlet for an adequate flow rate.

3. Check the fine filter in the water connection.

Remedy:

1. The device leaks a small amount for technical reasons. If the leak is severe, request authorised Customer Service.

The warranty conditions issued by our sales company responsible apply in all countries. We shall remedy possible malfunctions on your device within the warranty period free of cost, provided that a material or manufacturing defect is the cause. In a warranty case, please contact your dealer (with the purchase receipt) or the next authorised customer service site.

You can find more detailed information at: www.kaercher.com/dealersearch

We hereby declare that the machine described below complies with the relevant basic safety and health requirements in the EU Directives, both in its basic design and construction as well as in the version placed in circulation by us. This declaration is invalidated by any changes made to the machine that are not approved by us.

Product: Pressure cleaner (battery powered)

Type: 1.328-xxx

2014/35/EU

2014/30/EU

2011/65/EU

2000/14/EC

EN 60335-1

EN 60335-2-54

EN 62233: 2008

EN 55014-1: 2017

EN 55014-2: 2015

EN IEC 63000: 2018

2000/14/EG: Annex V

KHB 5

Measured: 86

Guaranteed: 89

KHB 6

Measured: 81

Guaranteed: 84

KHB 4-18

Measured: 82

Guaranteed: 84

The signatories act on behalf of and with the authority of the company management.

---

Documentation supervisor:

S. Reiser

Alfred Kärcher SE & Co. KG

Alfred-Kärcher-Str. 28 - 40

71364 Winnenden (Germany)

Ph.: +49 7195 14-0

Fax: +49 7195 14-2212

Winnenden, 2021/03/01

We hereby declare that the product described below complies with the relevant provisions of the following UK Regulations, both in its basic design and construction as well as in the version put into circulation by us. This declaration shall cease to be valid if the product is modified without our prior approval.

Product: Pressure cleaner (battery powered)

Type: 1.328-xxx

S.I. 2016/1101 (as amended)

S.I. 2016/1091 (as amended)

S.I. 2012/3032 (as amended)

S.I. 2001/1701 (as amended)

EN 60335-1

EN 60335-2-54

EN 62233: 2008

EN 55014-1: 2017

EN 55014-2: 2015

EN IEC 63000: 2018

S.I. 2001/1701 (as amended): Schedule 8

KHB 5

Measured: 86

Guaranteed: 89

KHB 6

Measured: 81

Guaranteed: 84

KHB 4-18

Measured: 82

Guaranteed: 84

The signatories act on behalf of and with the authority of the company management.

---

Documentation supervisor:

S. Reiser

Alfred Kärcher SE & Co. KG

Alfred-Kärcher-Str. 28 - 40

71364 Winnenden (Germany)

Ph.: +49 7195 14-0

Fax: +49 7195 14-2212

Winnenden, 2021/03/01