Before using for the first time, read the enclosed original instructions of this device, the battery pack and the charger as well as the safety instructions. Act in accordance with them.

Keep these documents for future reference or for future owners.

• If the operating instructions and safety instructions are not observed, the device can be damaged and dangers could arise for users and other persons.

• Notify the dealer immediately in the case of shipping damage.

• Check the package contents when unpacking for missing accessories or for damage.

The packing materials can be recycled. Please dispose of packaging in accordance with the environmental regulations.

Electrical and electronic devices contain valuable, recyclable materials and often components such as batteries, rechargeable batteries or oil, which - if handled or disposed of incorrectly - can pose a potential danger to human health and the environment. However, these components are required for the correct operation of the device. Devices marked by this symbol are not allowed to be disposed of together with the household rubbish.

Current information on content materials can be found at: www.kaercher.de/REACH

• This spray extraction device is intended for wet cleaning of upholstery, upholstered furniture and small carpeted areas.

• This device is suitable for commercial use.

1. Check hoses for damage before each startup.

1. Attach the spray/suction hose to the spray/suction hose connection on the device and click into place.

   ---

   

   Note

   Remove the spray/suction hose: Press the latch and pull the spray/suction hose out.

2. Connect the upholstery nozzle to the spray/suction hose and click into place.

   ---

   

• The total filling quantity is a maximum of 1.7 litres.

1. Mixing the cleaning solution: Mix the fresh water and the detergent in a clean container (concentration as specified for the detergent). Dissolve the detergent in the water.

2. Pull the fresh water container vertically upwards and out by the recessed grip.

3. Pull the container closure upwards and turn it sideways or unlock and remove the container lid.

   ---

   

4. Fill the fresh water container with the cleaning solution.

5. Close the container closure or fit the container lid making sure that it is firmly seated.

6. Fit the fresh water container down to the bottom of the device.

1. Slide the battery pack into the battery holder and lock it in place.

1. Pull the battery pack upwards and remove it.

2. Charge the battery pack according to the operating instructions of the charger manufacturer and the battery pack manufacturer.

1. Turn the power switch to position 1 (ON). The suction turbine and pump start.

1. Remove loose dirt from the object to be cleaned.

2. Press the lever on the upholstery nozzle to spray the cleaning solution.

   ---

   

3. Run over the surface to be cleaned in overlapping paths. Pull the nozzle backwards (do not push).

   Note

   When the waste water tank is full, a float switch closes the suction opening and the device runs at a higher speed.

4. Switch off the device immediately and empty the waste water container.

1. Turn the power switch to position 0 (OFF).

1. Pull the wastewater container vertically upwards and out by the recessed grip.

2. Unlock and remove the container lid.

   ---

   

3. Empty the wastewater container.

4. Close the container lid and make sure that it is firmly seated.

5. Fit the wastewater container down to the bottom of the device.

1. Pull the fresh water container vertically upwards and out by the recessed grip.

2. Pull the container closure upwards and turn it sideways or unlock and remove the container lid.

3. Empty the fresh water container.

4. Close the container closure or fit the container lid making sure that it is firmly seated.

5. Fit the fresh water container down to the bottom of the device.

1. Pull the wastewater container vertically upwards and out by the recessed grip.

2. Unlock and remove the container lid.

   ---

   

3. Remove the separator.

4. Carefully clean the container lid and separator with a damp cloth.

5. Carefully remove moisture with a dry cloth.

6. Assemble the container lid and the separator.

7. Close the container lid and make sure that it is firmly seated.

8. Fit the wastewater container down to the bottom of the device.

1. Connect the upholstery nozzle to the spray/suction hose and click into place.

2. Pour approximately 1.5 litres of tap water into the fresh water container. Do not add detergents.

3. Switch on the device.

4. Hold the upholstery nozzle over a drain.

5. Operate the lever on the upholstery nozzle and flush the device for 1 to 2 minutes.

6. Switch off the device.

1. Flush the device.

2. Emty the wastewater container and clean it under running water.

3. Empty the fresh water container.

4. Clean the wastewater container lid and separator.

5. To remove any remaining liquid in the spray/suction hose:

   1. Press the latch and pull the spray/suction hose out.

   2. Press the lever on the upholstery nozzle and pour the liquid into a suitable container (suchas a sink, bucket).

6. Let the device dry thoroughly: Remove the two container lids or open them slightly so that the remaining liquid can dry without leaving any residue.

7. Clean the fresh water filter (see “Care and maintenance”).

8. Clean the exterior of the device with a damp cloth.

9. To avoid unpleasant smells, remove all water from the device before long downtimes.

1. Store the spray/suction hose and upholstery nozzle as shown in the illustration.

   ---

   

2. Store the device in a dry room and secure it against unauthorised use.

1. Press the upholstery nozzle lever for spraying. The cleaning solution is sprayed on and vacuumed off at the same time.

1. Apply the cleaning solution and allow it to take effect for 10 - 15 minutes.

2. Clean the area as with normal soiling.

• Always work from light to shadow (from window to door).

• Always work from the cleaned to the uncleaned area.

• The more sensitive the covering the lower the concentration of detergent.

• Impregnating after wet cleaning prevents the textile from being quickly soiled again.

• To improve the cleaning result, rinse the object with clean water after using detergents.

For further information, please request the product information sheet and the EU safety data sheet for the relevant cleaning agent.

1. Fold the carrying handle upwards.

2. Grasp the device by the carrying handle for carrying.

3. When transporting the device in vehicles, secure it to prevent it from slipping or overturning in accordance with the respectively applicable guidelines.

The device may only be stored indoors.

1. Pull the battery pack upwards and remove it to prevent discharge.

• Regularly check the device-side contacts in the battery holder for contamination and clean with a damp cloth if necessary. Do not use detergents.

1. Pull the fresh water container vertically upwards and out by the recessed grip.

2. Unlock and remove the container lid.

3. Rinse the fresh water container with clear water.

4. Close the container lid and make sure that it is firmly seated.

5. Fit the fresh water container down to the bottom of the device.

1. Unscrew the union nut on the upholstery nozzle and remove the nozzle mouthpiece.

2. Clean the nozzle mouthpiece.

3. Replace the nozzle mouthpiece and secure it with the union nut.

• Device is not running 

• Device switches off automatically 

• No water emitted from the nozzle 

• Single-sided spray jet 

• Poor suction performance 

Remedy:

1. Charge the battery pack.

2. Insert the battery pack.

3. Check the battery pack for correct seating.

4. Switch on the device.

5. Allow the device to cool down (overheated board).

Remedy:

1. Allow the device or battery pack to cool down (overheated board).

2. Clean or dry the grids in the wastewater container cover.

Remedy:

1. Fill the fresh water container.

2. Check the connection of the upholstery nozzle and spray/suction hose for correct fit.

3. Clean or replace the nozzle mouthpiece.

4. Clean the fresh water filter.

5. The spray pump is defective, contact customer service.

Remedy:

1. Clean the nozzle mouthpiece.

Remedy:

1. Check the upholstery nozzle for clogging; clean if necessary.

2. Check the suction hose for clogging; clean if necessary.

If the malfunction cannot be corrected, the device must be checked by the Customer Service department.

• Device is not running 

• Device switches off automatically 

• No water emitted from the nozzle 

• Single-sided spray jet 

• Poor suction performance 

Remedy:

1. Charge the battery pack.

2. Insert the battery pack.

3. Check the battery pack for correct seating.

4. Switch on the device.

5. Allow the device to cool down (overheated board).

Remedy:

1. Allow the device or battery pack to cool down (overheated board).

2. Clean or dry the grids in the wastewater container cover.

Remedy:

1. Fill the fresh water container.

2. Check the connection of the upholstery nozzle and spray/suction hose for correct fit.

3. Clean or replace the nozzle mouthpiece.

4. Clean the fresh water filter.

5. The spray pump is defective, contact customer service.

Remedy:

1. Clean the nozzle mouthpiece.

Remedy:

1. Check the upholstery nozzle for clogging; clean if necessary.

2. Check the suction hose for clogging; clean if necessary.

The warranty conditions issued by our relevant sales company apply in all countries. We shall remedy possible malfunctions on your appliance within the warranty period free of cost, provided that a material or manufacturing flaw is the cause. In a warranty case, please contact your dealer (with the purchase receipt) or the next authorised customer service site.

Further information can be found at: www.kaercher.com/dealersearch

Further warranty information (if available) can be found in the service area of your local Kärcher website under "Downloads".

Only use original accessories and original spare parts. They ensure that the appliance will run fault-free and safely.

Information on accessories and spare parts can be found at www.kaercher.com.

Only use KÄRCHER original battery packs, not non-rechargeable batteries.

We hereby declare that the machine described below complies with the relevant basic safety and health requirements in the EU Directives, both in its basic design and construction as well as in the version placed in circulation by us. This declaration is invalidated by any changes made to the machine that are not approved by us.

Product: Spray retraction device

Type: 1.101-xxx

2006/42/EC (+2009/127/EC)

2011/65/EU

2014/30/EU

EN IEC 63000: 2018

EN 55014-1: 2017 + A11: 2020

EN 55014-2: 2015

EN 60335-1

EN 60335-2-68

EN 62233: 2008

-

The signatories act on behalf of and with the authority of the company management.

---

Documentation supervisor:

S. Reiser

Alfred Kärcher SE & Co. KG

Alfred-Kärcher-Str. 28 - 40

71364 Winnenden (Germany)

Ph.: +49 7195 14-0

Fax: +49 7195 14-2212

Winnenden, 2020/10/01

We hereby declare that the product described below complies with the relevant provisions of the following UK Regulations, both in its basic design and construction as well as in the version put into circulation by us. This declaration shall cease to be valid if the product is modified without our prior approval.

Product: Spray retraction device

Type: 1.101-xxx

S.I. 2008/1597 (as amended)

S.I. 2012/3032 (as amended)

S.I. 2016/1091 (as amended)

EN IEC 63000: 2018

EN 55014-1: 2017 + A11: 2020

EN 55014-2: 2015

EN 60335-1

EN 60335-2-68

EN 62233: 2008

-

The signatories act on behalf of and with the authority of the company management.

---

Documentation supervisor:

S. Reiser

Alfred Kärcher SE & Co. KG

Alfred-Kärcher-Str. 28 - 40

71364 Winnenden (Germany)

Ph.: +49 7195 14-0

Fax: +49 7195 14-2212

Winnenden, 2020/10/01