Before using the device for the first time, read this safety chapter, these original instructions, the original instructions and the safety booklet of the high-pressure cleaner. Proceed accordingly.

Keep the booklets for future reference or for future owners.

In addition to the notes in the operating instructions and safety booklet, you also need to take into consideration the general safety regulations and accident prevention guidelines applicable by law.

The pipe cleaning hose is intended exclusively for use with KÄRCHER high-pressure cleaners in unit classes K 2 to K 7.

The pipe cleaning hose is suitable for cleaning pipes and drains with the following dimensions:

• Diameter at least 40 mm (1.5")

• Bending radius at least 70 mm (2.75")

• Bending angle maximum 90°

---

Only use the pipe cleaning hose in private households.

The packing materials can be recycled. Please dispose of packaging in accordance with the environmental regulations.

Old devices contain valuable, recyclable materials that should be recycled. Therefore, please dispose of old devices using suitable collection systems.

Current information on content materials can be found at: www.kaercher.de/REACH

Only use original accessories and original spare parts. They ensure that the appliance will run fault-free and safely.

Information on accessories and spare parts can be found at www.kaercher.com.

The scope of delivery for the appliance is shown on the packaging. Check the contents for completeness when unpacking. If any accessories are missing or in the event of any shipping damage, please notify your dealer.

1. Get the high-pressure cleaner ready for use.

2. Lock the trigger of the high-pressure gun.

3. Fit the pipe cleaning hose on the high-pressure gun:

   1. Press the coupling plug of the pipe cleaning hose into the coupling socket of the high-pressure gun.

   2. Turn the coupling plug until it engages.

      ---

      

4. Depending on the application, select the rotating or static jet nozzle.

   ---

   

5. Screw the appropriate jet nozzle onto the pipe cleaning hose and tighten hand-tight.

   ---

   

   Note

   If needed, use a 13 mm open-end wrench on the flats of the jet nozzle to loosen it.

1. DANGER

   Risk of injury from high-pressure jet!

   If the pipe cleaning hose is not inserted into the pipe at least up to the minimum insertion mark, there is a risk of injury from the high-pressure jet.

   Only actuate the trigger of the high-pressure gun when the minimum insertion mark is entirely inside the pipe.

   During high-pressure operation, do not pull the pipe cleaning hose out of the pipe further than the minimum insertion mark.

   Keep body parts away from the pipe opening during high-pressure operation.

   Push the pipe cleaning hose into the pipe to be cleaned at least up to the minimum insertion mark.

   ---

   

2. Unlock the trigger of the high-pressure gun.

3. Pull the trigger of the high-pressure gun and slowly push the pipe cleaning hose further into the pipe.

   Note

   If the jet nozzle hits a blocked area, keep the trigger of the high-pressure gun pressed continuously and pull the pipe cleaning hose back slightly several times and release it again.

   If needed or in case of heavy contamination, repeat the cleaning process multiple times.

1. Release and lock the trigger of the high-pressure gun.

2. Switch off the high-pressure cleaner.

3. Pull the pipe cleaning hose out of the pipe.

4. Remove the pipe cleaning hose on the high-pressure gun.

5. Clean the pipe cleaning hose and the jet nozzle.

   ---

   

6. Shut down the high-pressure cleaner.

The warranty conditions issued by our relevant sales company apply in all countries. We shall remedy possible malfunctions on your appliance within the warranty period free of cost, provided that a material or manufacturing flaw is the cause. In a warranty case, please contact your dealer (with the purchase receipt) or the next authorised customer service site.

Further information can be found at: www.kaercher.com/dealersearch

Further warranty information (if available) can be found in the service area of your local Kärcher website under "Downloads".